SCREWDRIVER, FLAT TIP: plastic hdl, plain, %
in w flared tip. 8 in Ig blade, ? in female sq-
drive in end of hdl



SCREWDRIVER, FLAT TIP: plastic hdl, stght
sided tp, % in w, 5 in Ig blade, % in female
sq-drive in end of hdl


SCREWDRIVER. FLAT TIP. plastic hdl, (6 in tip
w, 5 in Ig blade, 3 in female sq-drive in end
of hdl



SCREWDRIVER, FLAT TIP: plastic hdl, w. pocket
clip, B in w flared tip. 2 in Ig blade



SCREWDRIVER, JEWELER'S SWIVEL KNOB:
0.070 in w tip, w.- I removable blade



STONE. SHARPENING: half-rd, syn, al-oxide,
fine grit, 4 in Ig x 3/ in w x K in thk o a


STONE, SHARPENING: natural, unmtd, hard
grit, sq. % in thk x Y in w x 3 in Ig


STONE, SHARPENING: natural, unmtd, hard
grit, rd-edge slip, 4 in Ig x 1% in w x 3 in thk
edge, ~ in thin edge


STONE. SHARPENING: rd, syn. al-oxide or sili-
con carbide, fine grit.4 in Ig x % in thk


FSN 5345584-455


STONE, SHARPENING: sq, syn, al-oide or sili-
con carbide, fine grit, 6 in Ig x % in w x %
in thk



STONE, SHARPENING: tri, syn. al-oxide or sili-
con carbide, fine grit, 4 in Ig x 3 in w x Y
in thk



TAPE, MEASURING: S, general purpose dis-
tance measuring type, Y in w x 72 in Ig, grad
in units of Y in, 3'f in, and 1 in, 3, in incre-
ments 1st 6 in upperside, 3f6 in increments on
bal of ribbon. Ih to rh
reading, w 'case, butt
end type, pull-push
rewind


TOOL BOX, PORTABLE: S, enmld fin and parnt-
ed, 16 in Ig x 8/2 in w x 10% in o a excl
projections, 5 drawers,
w, panel front. Ikg fa-
 cilities incl, nonintegral
 lock. 2 additional han-
 dles located on sides


 VISE, BENCH, CLAMP BASE:
 stationary base, w.. anvil
 back, 2! in w jaw, 2%
 in jaw opng


 WRENCH, OPEN END, ADJUSTABLE: sgle.hd
 type, 0 to 1.135 in opng, 10 in Ig o a



 WRENCH. OPEN END, FIXED- sgle-hd type, Y
 in opng. 3 in thk hd, 4' in Ig o'a

FS 52029-12