1MA SUNNMR'S QADRINT
 GUNNER'S QUADRANT M1A1-Shoes smooth LEV
 and without nicks or burrs. Figures easy to CENTERED?
 read. (If necessary, gently clean the dirt out
 of the numbers with a small brush.) Microm-
 eter knob turns freely but without play. Level
 bubble can be centered. Teeth not chipped or a
 burred. Error, not more than 0.4 mil on end-
 for-end test. (If the error is greater than this i
 turn the quadrant in to support as soon as
 possible.) M82 case in good shape with all W
 cork gaskets and protective strips present TEETH
 and secure. Latches not broken. OKAY?
 M26 FUZE SETTER-All screws present and tight. Battery com-
 partment in handle not corroded. The 2 BA-42 (C batteries) not
 burned out. Bulb lights up when handle is in straight-up position and
 handle button is pressed. (NOTE: It takes quite a bit of pressure to
 seat the cap even when the threads are clean and unburred-which
 they should be. Wing nut holds pointer securely at indicated number.
 Both inner and outer scale numbers easy to read. (Clean 'em if they're
 not.) Arrow showing direction of turn clear. Use only on left turn
 fuzes.
 M27 FUZE SETTER-No big cuts or nicks on WHO'S
 inner bearing surface. Screwdriver end not BEEN USINGC-
 broken or chipped. __ THIS TO LOOSEN


M63 FUZE SETTER-This is used with right turn fuzes M562, M563.
M564 and M565, and its stock number is FSN 1290-966-9318
(5800967). Until you get one you can use wrench M16. If you already
have one, check these points: Prongs on socket not troken off.
Recess on handle fits locking latch on socket securely without play.
Red night glass not cracked or broken. Night switch turns on light.


.r'~1, 01, I- T i ;. '-Paint OK in alternate white and red bands.
Bare metal lightly lubed. Pin not broken oft Spring strong enough
to hold post in position. Posts not bent (Roll 'em on a flat surface
or use a level to make sure they're straight.)